Bought new mobile with Core Dou T2300. Installed boinc 5.8.8, connected to cimatepredicion.net and downloaded 2 WUs.
http://climateapps2.oucs.ox.ac.uk/cpdnboinc/show_host_detail.php?hostid=597832

But only one started crunching. I remember, that I\'ve seen someday number of CPUs to use for crunching, bat could not find it this time. I\'ve suspended the 1st WU and the 2nd started crunching, then suspended 2nd - 1st started, while 2nd persists in memory (2 pairs of precesses(EXEs)), but only one uses CPU time. THe 2nd WU in boinc \"waits\". How to make boinc run two WUs same time?

---

Look on your \"Your Account\" page for the Preferences click on General Preferences and then under the Processor Usage section, its the next to last item. If you have separate settings for Home, Work, etc., make sure you\'re changing the right one.

Then in your BOINC client, perform an update for the project and it will refresh your preferences to what you just changed.

I\'ve been running a T2500 with no problems for quite a while. Just make sure it stays cool and you shouldn\'t have any problems.

---

Mark

Also, be careful of Vista...

If you reboot, vista may trash the running WU (vista shuts down too fast and stuff isn\'t saved correctly). You may have hit your daily limit and not know it!

See this thread on the boinc forums....

http://boinc.berkeley.edu/dev/forum_thread.php?id=1689

BTW, I\'m running with 60000 as the value discussed.....

---